This guide is to assist only in the design application. Installation must comply with all relevant Australian and New Zealand Building standards. Building engineers, architects and designers must be consulted to ensure the details in this guide are appropriate for the application and the project’s documentation. Always refer to architectural and engineer drawings for all setting out dimensions.
Load-bearing walls shall be supported separately in accordance with the project engineer’s and architect design. Control joint locations should be marked out in accordance with the engineering or architect documentation. Restraint of walls is the responsibility of the builder or installer;
Dingo building products accepts no responsibility for the design or selection of supporting walls, lintels, beams, columns or other structural members shall be specified by the project engineer, architect and designer and in accordance with the Australian & New Zealand Building standards.